littleqert.blogg.se - Sony eyeconnect

#Sony eyeconnect how to#
#Sony eyeconnect manuals#
#Sony eyeconnect manual#

MediaLink automarically displays your album art, photo and video previews on your PlayStation 3. If you are unable to pair your devices, a different solution is available for troubleshooting.If you turn off this unit or the Bluetooth audio device before the Bluetooth connection is complete, pairing information is not memorized and pairing will not be completed.Both the POWER (green) indicator and the COMMUNICATION STATUS (blue) indicator will light up steady indicating that pairing is complete and the pairing information is memorized on this unit.Refer to the operating instructions supplied with your Bluetooth device for detailed information. Some Bluetooth devices connect automatically. Depending on the connected Bluetooth device, a passcode may not be needed.This unit cannot be paired with a Bluetooth audio device whose passcode is not 0000. If the unit requires a pass code, the passcode is fixed to 0000.The Passcode may also be referred to as Passkey, PIN code, PIN number or Password.If passcode input is required on the display of the Bluetooth audio device, input 0000 (four zeros).NOTE: If the model number of this unit does not display, start over from step 1. Select the model number of this unit shown in the display of the Bluetooth audio device.Depending on the device, Bluetooth connection may start automatically.Some devices cannot display the list of detected devices.The list of detected devices appear on the display of the Bluetooth audio device.Perform the pairing procedure on the Bluetooth audio device to detect this unit.When the POWER (green or red) indicator and the COMMUNICATION STATUS (blue) indicator starts flashing together, release the ID SET button (for the speaker).When pairing for the first time, press and hold the / POWER button for about 2 seconds while the Bluetooth headphones are turned off.If the pairing mode is canceled while performing this procedure, start over from step 1.

The pairing mode is canceled and this unit is turned off after about five minutes.

#Sony eyeconnect manual#

The button that must be held down to enter Pairing mode differs depending on the product you use, so check the instruction manual for your Bluetooth headphones.

The Bluetooth headphones enter Pairing mode. When the indicator starts to blink quickly, release the button.

Press and hold the ID SET button (for the speaker) or the / POWER button (for the headphones) for more than 7 seconds while the Bluetooth headphones are turned off.Turn on the connecting Bluetooth device and place it within 3 feet (1 meter) of this unit.

If the unit powers on when you connect it to a power source, press and hold the POWER button to turn the unit off.

Verify that the power of the unit is off.

Make sure that both devices have sufficient charge or power.

Be sure to place the Bluetooth® wireless devices within 1 meter (3 ft) of each other.

#Sony eyeconnect manuals#

Manuals are posted on your model support page. If model-specific information is required to complete any of the steps in this solution, refer to the operating instructions supplied with the product.

#Sony eyeconnect how to#

If connecting to an NFC-capable device via One-touch, refer to this answer on How to listen to music from an NFC-capable device.Check Applicable Products and Categories for details. IMPORTANT: This article applies only to specific products and/or operating systems.